V.92 Commands - Multitech MultiModem DID MT5634ZBA-DID User Manual

MultiModemDID User Guide

V.92 Commands

Command: +PCW= n Call Waiting Enable
Values:
Default:
Description:
Command: +PIG= n
Values:
Default:
Description:
Command: +PMH= n Modem on Hold Enable
Values:
Default:
Description:
Command: +PMHF V.92 Modem Hook Flash
Values:
Default:
Description:
Chapter 4 - AT Commands, S-Registers, Result Codes
n = 0, 1, or 2
2
Controls the action to be taken upon detection of a call waiting
tone in V.92 mode. Values specified by this command are not
modified when an AT&F command is issued.
+PCW=0 Toggles V.24 Circuit 125 and collects Caller ID if enabled by
+VCID
+PCW=1 Hangs up
+PCW=2 Ignores V.92 call waiting
+PCW=? Displays the allowed values
+PCW? Displays the current value
PCM Upstream Ignore
n = 0 or 1
1
Controls the use of PCM upstream during V.92 operation. PCM
upstream allows faster upload speeds to a V.92 server.
+PIG=0 Disables PCM upstream
+PIG=1 Enables PCM upstream
+PIG=? Displays the allowed values
+PIG? Displays the current value
n = 0 or 1
1
Controls if modem on hold procedures are enabled during V.92
operation. Normally controlled by a modem on hold program.
Values specified by this command are not modified when an
AT&F command is issued.
+PMH=0 Enables V.92 modem on hold
+PMH=1 Disables V.92 modem on hold
+PMH=? Displays the allowed values
+PMH? Displays the current value
n/a
n/a
Causes the DCE to go on-hook for a specified period of time,
and then return off-hook for at least a specified period of time.
The specified period of time is normally one-half second, but
may be governed by national regulations. "ERROR" is returned
if MOH is not enabled.
28