Expert Adjustment] - Oce VarioLink 2222c User Manual

7
7.1.7

[Expert Adjustment]

Make adjustments so that output quality is increased.
%
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment].
Settings
[AE Level Adjustment]
[Printer Adjustment]
[Finisher Adjustment]
7-10
Configure the initial value for AE (auto exposure). The higher the setting,
the more that the original background is emphasized.
Adjust the starting print position and defective print images caused by pa-
per type features.
d
Reference
The starting print position is factory-adjusted. Normally, you
are not required to change the set values.
[Leading Edge Adjustment]
[Centering]
[Leading Edge Adjustment (Du-
plex Side 2)]
[Centering (Duplex 2nd Side)]
[Erase Leading Edge]
[Vertical Adjustment]
[Media Adjustment]
Adjust the staple, folding, and punch position of the Finisher FS-527. Oth-
erwise, adjust where to place the paper alignment plate of the Finisher FS-
529.
This item is displayed if the Finisher FS-527 or Finisher FS-529 is in-
stalled.
d
Reference
Create a sample in advance, and then adjust them while
checking the sample.
[Center Staple Position]
[Half-Fold Position]
[Punch Horizontal Position Ad-
justment]
[Punch Regist Loop Size Adjust-
ment]
[Paper Alignment Plate Settings]
[System Settings]
p. 7-13
p. 7-13
p. 7-13
p. 7-13
Adjust leading edge erase width.
For details on displaying this item,
contact your service representative.
Adjust the feed direction zoom ratio of
paper types.
For details on displaying this item,
contact your service representative.
p. 7-14
p. 7-14
p. 7-15
p. 7-15
p. 7-16
p. 7-16
VL3622c/VL2822c/VL2222c
7.1