Uplink Port Leds In Ex6200 Switches; Figure 10: Leds On The Uplink Port On An Ex6200 Switch; Table 14: Link/Activity Led On An Uplink Port On Ex6200 Switches - Juniper EX6210 Complete Hardware Manual

Uplink Port LEDs in EX6200 Switches

Table 14: Link/Activity LED on an Uplink Port on EX6200 Switches

LED
Link/Activity
Copyright © 2014, Juniper Networks, Inc.
Each Switch Fabric and Routing Engine (SRE) module has four uplink ports on its front
panel.
Each uplink port on EX6200 switches has two LEDs that indicate link/activity and port
status (see Figure 10 on page

Figure 10: LEDs on the Uplink Port on an EX6200 Switch

Status Link/Activity
Link/ Status
Activity
Table 14 on page 29 describes the Link/Activity LED.
Color
Green
Table 15 on page 30 describes the Status LED. From the Idle menu of the master SRE
module LCD, use the Enter button on the LCD panel to toggle between the ADM, DPX,
PoE, and SPD indicators.
29).
State and Description
Blinking—The port and the link are active, and there is link
activity.
On steadily—The port and the link are active, but there is no
link activity.
Off—The port is not active.
Chapter 2: Component Descriptions
29