Installing A Transceiver In An Ex Series Switch - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation

Installing a Transceiver in an EX Series Switch

164
NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp
Failure to do so can result in significant delays if you need replacement parts.
This note applies if you change the type of power supply from AC to DC or
DC to AC or add a new type of line card. It does not apply if you replace these
components with the same type of component.
Removing a Line Card from an EX6200 Switch on page 219
48-Port RJ-45 Line Card in an EX6200 Switch on page 31
48-Port PoE+ Line Card in an EX6200 Switch on page 32
The transceivers for EX Series switches are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.
NOTE: After you insert a transceiver or after you change the media-type
configuration, wait for 6 seconds for the interface to display operational
commands.
Use only optical transceivers and optical connectors purchased from Juniper Networks
for your EX Series switches.
NOTE: On an EX3200 switch, if you install a transceiver in a 1-Gigabit Ethernet
uplink module port, a corresponding network port from the last four built-in
ports is disabled. For example, if you install a transceiver in the uplink module
port 3 (
ge-0/1/2
disabled port is not listed in the output of
Before you begin installing a transceiver in an EX Series switch, ensure that you have
taken the necessary precautions for safe handling of lasers (see
Guidelines and Warnings for EX Series Switches" on page
Ensure that you have a rubber safety cap available to cover the transceiver.
Figure 59 on page 166 shows how to install a QSFP+ transceiver. The procedure is the
same for all types of transceivers.
), then the built-in port 23 ( ) is disabled. The
ge-0/0/22
show interface commands.
"Laser and LED Safety
265).
Copyright © 2014, Juniper Networks, Inc.
.