Click IP Application > DiffServ in the navigation panel to display the screen as
shown.
Figure 142 IP Application > DiffServ
The following table describes the labels in this screen.
Table 86 IP Application > DiffServ
LABEL
Active
Apply
Cancel
30.3 DSCP-to-IEEE 802.1p Priority Settings
You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to
prioritize all traffic based on the incoming DSCP value according to the DiffServ to
IEEE 802.1p mapping table.
The following table shows the default DSCP-to-IEEE802.1p mapping.
Table 87 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE 0 – 7
IEEE 802.1p
MES-3528 User's Guide
DESCRIPTION
Select this option to enable DiffServ on the Switch.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
8 – 15
16 – 23 24 – 31 32 – 39 40 – 47 48 – 55 56 – 63
0
1
2
Chapter 30 Differentiated Services
3
4
5
6
7
265