Mvr Group Configuration - ZyXEL Communications MES-3528 User Manual

Table 60 Advanced Application > Multicast > Multicast Setting > MVR (continued)
LABEL
Delete
Cancel

24.8 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive
multicast data sent to this multicast group.
Configure MVR IP multicast group address(es) in the Group Configuration
screen. Click Group Configuration in the MVR screen.
Note: A port can belong to more than one multicast VLAN. However, IP multicast
group addresses in different multicast VLANs cannot overlap.
Figure 106 Advanced Application > Multicast > Multicast Setting > MVR: Group
Configuration
The following table describes the labels in this screen.
Table 61 Advanced Application > Multicast > Multicast Setting > MVR: Group
Configuration
LABEL
Multicast
VLAN ID
Name
Start
Address
MES-3528 User's Guide
DESCRIPTION
To delete a multicast VLAN(s), select the rule(s) that you want to remove
in the Delete column, then click the Delete button.
Click Cancel to clear the Delete check boxes.
DESCRIPTION
Select a multicast VLAN ID (that you configured in the MVR screen) from
the drop-down list box.
Enter a descriptive name for identification purposes.
Enter the starting IP multicast address of the multicast group in dotted
decimal notation.
Refer to Section 24.1.1 on page 193
addresses.
Chapter 24 Multicast
for more information on IP multicast
205