Mvr Configuration Example - ZyXEL Communications MES-3528 User Manual

Chapter 24 Multicast
Table 61 Advanced Application > Multicast > Multicast Setting > MVR: Group
Configuration
LABEL
End Address
Add
Cancel
MVLAN
Name
Start
Address
End Address
Delete
Cancel

24.8.1 MVR Configuration Example

The following figure shows a network example where ports 1, 2 and 3 on the
Switch belong to VLAN 1. In addition, port 7 belongs to the multicast group with
VID 200 to receive multicast traffic (the News and Movie channels) from the
remote streaming media server, S. Computers A, B and C in VLAN are able to
receive the traffic.
Figure 107 MVR Configuration Example
206
DESCRIPTION
Enter the ending IP multicast address of the multicast group in dotted
decimal notation.
Enter the same IP address as the Start Address field if you want to
configure only one IP address for a multicast group.
Refer to Section 24.1.1 on page 193
addresses.
Click Add to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID.
This field displays the descriptive name for this setting.
This field displays the starting IP address of the multicast group.
This field displays the ending IP address of the multicast group.
Select Delete Group and click Delete to remove the selected entry(ies)
from the table.
Select Cancel to clear the checkbox(es) in the table.
for more information on IP multicast
MES-3528 User's Guide