Configuring Dscp Settings - ZyXEL Communications MES-3528 User Manual

Chapter 30 Differentiated Services

30.3.1 Configuring DSCP Settings

To change the DSCP-IEEE 802.1p mapping click the DSCP Setting link in the
DiffServ screen to display the screen as shown next.
Figure 143 IP Application > DiffServ > DSCP Setting
The following table describes the labels in this screen.
Table 88 IP Application > DiffServ > DSCP Setting
LABEL
0 ... 63
Apply
Cancel
266
DESCRIPTION
This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-
down list box.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when
you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES-3528 User's Guide