Load Factory Default - ZyXEL Communications MES-3528 User Manual

Chapter 32 Maintenance
Table 93 Management > Maintenance (continued)
LABEL
Load
Factory
Default
Save
Configuratio
n
Reboot
System

32.2 Load Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
In the Maintenance screen, click the Click Here button next to Load Factory
1
Default to clear all Switch configuration information you configured and return to
the factory defaults.
Click OK to reset all Switch configurations to the factory defaults.
2
Figure 152 Load Factory Default: Start
In the web configurator, click the Save button in the top of the screen to make the
3
changes take effect. If you want to access the Switch web configurator again, you
may need to change the IP address of your computer to be in the same subnet as
that of the default Switch IP address (192.168.1.1).
278
DESCRIPTION
Click Click Here to reset the configuration to the factory default settings.
Click Config 1 to save the current configuration settings to Configuration
1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration
2 on the Switch.
Click Config 1 to reboot the system and load Configuration 1 on the
Switch.
Click Config 2 to reboot the system and load Configuration 2 on the
Switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the Switch.
MES-3528 User's Guide