Displaying Call Charges - Gigaset 3015 Classic Operating Instructions Manual

Gigaset 3015 Classic, ÜBasis, A31008-G3015-B001-1-19
Cost-effective telephoning
Press keys:
System PIN
e. g.
System PIN
20

Displaying call charges

Requirement: You have requested transmission of counting pulses
from your telephone company and the correct price per unit is set.
Display begins after the first counter pulse is received.
e. g.
Setting the price per unit
You must set the price per unit to ensure that the correct call charges
are displayed.
If you set the price per unit to zero, units are displayed instead of
call charges.
Every modification sets the counters back to zero. The
amounts in the call allowance accounts are retained.
If the price per unit is set to zero, then the amounts in the
call allowance accounts are also erased.
Initiate the function.
Enter and confirm the system PIN of the base station (factory setting:
0000) – the current setting is displayed.
If necessary use the
places (00.00) and without decimal places (0).
Enter the price per unit.
If necessary use the
is the setting for displaying only units.
Save the setting (confirmation beep) and terminate the function.
Displaying/deleting charges
You can display the charges per mobile unit as well as charges for all
mobile units. If units are set, then, of course, whole units will be dis-
played.
Initiate the function.
Enter and confirm the system PIN (factory setting: 0000) – the num-
bers of all registered mobile units are displayed (flashing).
KOSTEN.FM
Charges for current call
Total charges for all calls
key to switch between display with decimal
key to set the charge factor to "00.0 0 ". This
20.12.99