Troubleshooting - SMART MX 16 Operating Instructions Manual

Troubleshooting

Symptom
The display does
not light up.
No sound or picture,
the receiver LED is
illuminated.
No sound or picture.
The TV set shows
no picture.
Poor picture,
Blockage problems
The remote control
does not work.
If, despite everything, a fault cannot be rectified, then please contact
a specialist dealer or the manufacturer.
Possible cause and remedy
The power cable is not connected..
Plug the power cable into the power socket..
The power switch is not on.
Switch the receiver on.
The receiver is in Standby mode.
Press the "Power" button. The receiver switches itself on
and the programme appears on the TV screen.
The antenna is not directed at the satellite.
Align the antenna correctly.
No or only a weak signal.
Check the cable connection from LNB to receiver and from
receiver to the auxiliary equipments.
Align the antenna correctly.
The system is not correctly connected up.
Check the connection of the SCART or HF cable.
The TV set is not in AV mode.
Switch the TV set onto the corresponding AV input.
The antenna is not correctly aligned on the satellite.
The LNB is defective.
The batteries are exhausted.
Replace them with new ones.
The remote control is not correctly directed.
Aim the remote control at the front panel of the receiver and
see that nothing is standing between remote control and
receiver.
11BTroubleshooting
52