SMART MX 16 Operating Instructions Manual page 49

Select the option "Yes" to install the update, or
"No", to reject the update.
If the option "Yes" was selected, now go to the menu option
"Works settings" on page 34 and reset the receiver.
The software update is now completed.
Update software from receiver to receiver
The receiver's internal software can also be updated with the help of
a second receiver..
Caution!
Only two receivers of the same type may be used, or else the
receivers could possibly be rendered unusable.
Only use a serial cable with 1:1 coupling (no null modem
cable!). When connecting from receiver to receiver the
following coupling is required: 1/4 cross wire, 2/3 cross wire,
7/8 cross wire, 5/5 1:1, 9/9 1:1, 6 open ("Loop-through
cable"). This cable can be obtained from a specialist dealer.
Take these instructions to the dealer.
Connect both receivers with a serial cable.
(RS-232C cable, cross-wired) through the RS-232C interface
(serial interface).
Switch on the receiver with the newest software (source receiver).
Switch on the receiver to be updated.
Caution!
Do not switch the receivers off during an update, otherwise the
receivers may not operate correctly.
Press the "Setup" button.
Enter the PIN code.
The setup sub-menus will now appear.
Using the numeric buttons, enter the number 5732.
The TV now shows the "Box-to-Box Copy" sub-menu.
Select the desired option using the arrow buttons " " and " ".
To start the transmission press the "OK" button.
9BOperation
49