Troubleshooting - SMART MX 04 User Manual

Troubleshooting

Fault Phenomenon
The display shows
nothing.
No volume or picture,
the LED is on.
No volume or picture.
No or only faint signal.
No picture on TV
screen.
TV-Set is not in AV
mode.
Bd picture,
block defect.
TheLNB is defective.
The remote control
does not work.
The remote control
does not always work.
If you cannot find out what is wrong with your device, please contact your local
dealer.
Smart MX 04
Probable reasons and solution
The power cable is not plugged in.
Put the plug of the power cable into the mains
socket.
The power switch is off. Switch power on at the
backside of the device.
The receiver is on standby.
Press the power button. The receiver will switch on
and the program is on the screen.
The antenna is not adjusted to the satellite.
Adjust the antenna correctly.
Please check the cable between LNB and receiver
and between receiver and connected devices.
Adjust the antenna.
The system is connected incorrectly.
Check connection of SCART cable.
Switch the TV set on AV input.
The antenna is not adjusted to the satellite.
Adjust the antenna.
Replace the LNB.
The batteries are empty.
Replace them with new ones.
Focus the remote control to the front side of the
receiver and assure that nothing else is between
the remote control and the receiver.
Troubleshooting
EN 67