Installing The Lnb Cable - SMART MX 16 Operating Instructions Manual

Installing the LNB cable

For installing an IF plug on the co-axial cable wire strippers and
cutting pliers will be required.
Cut off 8mm co-axial cable down to the internal core at both ends.
Carefully cut 10mm of external isolation material off, so that the
braided sheath is showing.
Turn back the braided sheath and turn it over the outer isolation
material, ensuring that it does not touch the internal core
Remove the internal isolation material up to 2mm before the
braided sheath.
Turn the IF plug onto the turned-back braided sheath until the plug
meets the internal isolation material..
The braided sheath should not protrude behind the end of
the plug.
Shorten the internal core with cutting pliers, so that it protrudes at
most 1mm out of the plug.
Connection of a SCART cable
Screw the IF plug of the LNB cable on to the receiver's antenna
input marked "ANT INPUT".
Plug the SCART cable into the receiver's SCART connection
marked "TV".
Connect the SCART cable with the TV set. Observe the operating
instructions of the TV set.
If a video cassette recorder is to be connected, then plug a
SCART cable in the receiver's SCART connection marked "VCR".
Connect the SCART cable with the video cassette recorder.
Observe the operating instructions of the video cassette recorder.
If a music centre is to be connected, then plug the cinch cable in
the receiver's sockets marked "AUDO R" and "AUDIO L".
6BOverview of the equipment
15