Switching The Automatic Check Of The Raps Listing On And Off; Manual Check Of The Raps Listing - SMART MX 16 Operating Instructions Manual

Digital satellite receiver with integrated cryptoworks interface

Table of Contents

Switching the automatic check of the RAPS

listing on and off

RAPS is set, so that after switching-on the receiver automatically

checks if a new RAPS listing with changed transmitter data is

available. The check lasts about 15 seconds.

The check can be stopped by pressing the "EXIT" button. If the

automatic update process is not required, then proceed as follows:

Press the "SET UP" button and enter the PIN code using the

numeric buttons.

Select the sub-menu "System Settings" using the arrow buttons

" " or " ".

Select the menu option "RAPS Scanning" using the arrow buttons

" " or " ".

Select the menu option "Off" to turn off the automatic check

using the arrow buttons " " or " " or

The option "On" to turn the automatic check on again.

Select the menu option "System Settings". Here is found the

option "RAPS Scanning".

Press the "OK" button.

If "Off" was selected, the message "checking RAPS date" will not

appear, and the receiver switches directly to the last channel listing

stored.

If the automatic check of the RAPS listing has been switched off, then

an update can be carried out manually.

Press the "MENU" button and select the sub-menu "Software

Version" using the arrow buttons " " or " ".

using the arrow buttons " " and " " or " " and „ " select the

menu option "Update" in the "RAPS" sub-menu.

Press the "OK" button.

Enter the PIN code using the numeric buttons.

The current settings for RAPS will now be displayed and the receiver

checks if a new RAPS listing is available. If the data in the fields

14BRAPS

Table of Contents