2. hArDwAre
Component DesCriptions
Front Panel
As listed below, the leds indicate the current status of the router.
LED
PWR (green)
WlAn (yellow)
AdSl (green)
lAn (Ports 1-4)
Rear Panel
Antenna Connector:
This is a reverse
SMA connector,
allowing easy
connection to an
external antenna.
Reset button: This can be used to reset the router or to restore the factory default
settings. Press the button (using a pencil tip can help) for less than five seconds
to re-boot the router and save any configurations that have been set up.
If problems persist after the simple re-boot — or if you've forgotten your password
— hold the button in for longer than five seconds to reset the router to its factory
default settings. NOTE: The factory default settings will replace any others that
have been configured.
Power outlet: The 12 V dC power adapter included with the device is connected
here.
LAN ports: The four local area network (lAn) ports are for connections to PCs,
lAns, printers, servers, hubs and so forth.
ADSL: The enclosed RJ- 1 1 phone line connects this outlet to an AdSl/telephone
network.
HARdWARe
Mode
Status
on
Ready for operation.
off
The wireless lAn is disabled.
blinking
Wireless traffic is being transmitted/received.
on
Successful connection to an AdSl dSlAn.
blinking
no connection.
on
The lAn cable is connected to the router.
off
no network connection.
blinking
network traffic is being transmitted/received
through the lAn port.