Assembling The Speakers [Bt205] - Panasonic SC-BT205 Operating Instructions Manual

Assembling the speakers [BT205]

Front speakers and Surround speakers
Preparation
≥To prevent damage or scratches, lay down a soft cloth and
perform assembly on it.
Make sure you have all the indicated components before starting assembly, setup, and connection.
Keep the screws out of reach of children to prevent swallowing.
2 Front speakers
2 Surround speakers
1
2
Position the cable
between the ridges.
Leave about 120 mm
Speaker assembly option
Thread the speaker cable
through the base.
Leave about 120 mm
You can remove and use the cable
from the stand. To reattach the
cable, refer to page 43.
≥Be careful not to cross (short-circuit) or reverse the polarity of the speaker wires as doing so may damage the
Do
Not
NOTE
Preventing the speakers from falling
≥You will need to obtain the appropriate screw eyes to match the walls or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
e.g.
String (not included)
Thread from the wall to the speaker and tie tightly.
Screw eye
(not included)
Rear of the speaker
4 Stands
(with cables)
Tighten securely.
Attach the speaker.
speakers.
Approx.
150 mm
Wall
≥For assembly, use a Phillips-head screwdriver (not included).
≥For wall mount, refer to page 43.
4 Bases
Slide into the groove.
Insert the wire fully.
: White
: Blue
Push!
Press into the groove.
Tighten securely.
Insert the wire fully.
: White
: Blue
Push!
Press into the groove.
Tighten securely.
Slide into
the groove.
Caution
≥Do not stand on the base. Be cautious when children are
near.
e.g.
16 Screws
2
1
1
DO
NOT
RQT9445
7