Radio; Listening To The Radio; Setting Up The Radio; Listening/Confirming The Preset Channels - Panasonic SC-BT205 Operating Instructions Manual

Listening to the Radio

Setting up the radio

Numbered
buttons
STATUS
Presetting stations automatically
Up to 30 stations can be set.
1 Press [RADIO] to select "FM".
This unit: Press [SELECTOR].
2 Press [STATUS] to select the position to start the
auto preset search.
Each time you press the button:
LOWEST (factory preset):
To begin auto preset with the lowest frequency (FM87.50).
CURRENT:
To begin auto preset with the current frequency.
To change the frequency, refer to "Manual tuning"
*
( right).
3 Press and hold [OK].
Release the button when
"AUTO" is displayed.
The tuner starts to preset all the stations
it can receive into the channels in
ascending order.
≥"SET OK" is displayed when the stations are set, and the
radio tunes to the last preset station.
≥"ERROR" is displayed when automatic presetting is
unsuccessful. Preset the stations manually (
RQT9445
26
1 2 3
abc def
4 5 6
ghi jkl mno
p
7 8 9 w
qrs tuv xyz
0

RADIO

RADIO
EXT-IN
SEARCH
SEARCH SEARCH
SEARCH
,
, OK
OK
STATUS DISPLAY AUDIO
AUDIO
DISPLAY
SD CARD
SETUP MIC SELECTOR SELECTOR TUNE TUNE
TUNE
SELECTOR
right).

Listening/confirming the preset channels

1 Press [RADIO] to select "FM".
2 Press the numbered buttons to select the channel.
To select a 1-digit number
e.g., 1: [1]
To select a 2-digit number
e.g., 12: [1]
Alternatively, press [W, X] or [2, 1].
When a stereo FM broadcast is being
received, "ST" lights in the display.
≥The FM setting is also shown on the TV display.
∫ If noise is excessive
When FM is selected
Press [AUDIO] to display "MONO".
Press the button again to cancel the mode.
≥The mode is also cancelled when
you change the frequency.
≥This setting can be preset for each broadcasting station.
When "MONO" appears follow procedures 1 and 2 in
"Presetting stations manually" (
Manual tuning
1 Press [RADIO] to select "FM".
2 Press [SEARCH6] or [SEARCH5] to select
the frequency.
≥Main unit:
Press [X TUNE W] to select the frequency.
≥When a radio broadcast is
being received, "T" lights in
the display.
≥To start automatic tuning,
press and hold [SEARCH6, SEARCH5] (main unit:
[X TUNE W]) until the frequency starts scrolling. Tuning
stops when a station is found.
∫ Presetting stations manually
Up to 30 stations can be set.
1 While listening to the radio broadcast
Press [OK].
2 While "P" is flashing on the display
Press the numbered buttons to select a channel.
To select a 1-digit number
e.g., 1: [1]
*
To select a 2-digit number
e.g., 12: [1]
A station previously stored is overwritten when another station
is stored in the same channel preset.

RDS broadcasting

The unit can display the text data transmitted by the radio data
system (RDS) available in some areas.
If the station you are listening to is transmitting RDS signals,
"RDS" will light up on the display.
While listening to the radio broadcast
Press [DISPLAY] to display the text data.
Each time you press the button:
PS: Programme service
PTY: Programme type
OFF: Frequency display
NEWS
AFFAIRS
INFO
SPORT
EDUCATE
DRAMA
CULTURE
SCIENCE
* "M.O.R. M"=Middle of the road music
RDS displays may not be available if reception is
poor.
NOTE
[OK].
[2]
T
below).
T
[OK].
[2]
PTY displays
VARIED FINANCE
POP M CHILDREN
ROCK M SOCIAL A
M.O.R. M* RELIGION
LIGHT M PHONE IN
CLASSICS TRAVEL
OTHER M LEISURE
WEATHER JAZZ
ST
MONO
COUNTRY
NATIONAL
OLDIES
FOLK M
DOCUMENT
TEST
ALARM