Appendix; Care; Contact With Liquid; Questions And Answers - Siemens Gigaset S430 User Manual

Appendix

Care

¤
Wipe the base station and handset with
a damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth. This can cause
static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Switch the handset off and remove
the batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not activate the handset again
until it is dry.
When it has fully dried out you will nor-
mally be able to use it again.
!

Questions and answers

If you have any queries about the use of
your phone, you can contact us 24/7 at
www.siemens.com/gigasetcustomercare.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The batteries are flat.
¥
Charge or replace the batteries (page 7).
The handset does not respond to a key press.
The keypad lock is activated.
¥
Press and hold the hash key
"Base station x" flashes in the display.
1. The handset is outside the range of the base
station.
¥
Reduce the distance between handset/
base station.
2. The handset has been de-registered.
¥
Register the handset (page 25).
3. The base station is not switched on.
¥
Check the base station mains adapter
(page 6).
Base Search flashes in the display.
The handset is set for
tion is switched on or within range.
¥
Reduce the distance between handset/base
station.
¥
Check the base station mains adapter
(page 6).
Handset does not ring.
1. The ringtone is switched off.
¥
Activate the ringtone (page 35).
2. Call diversion set to
¥
Switch off Call Diversion (page 14).
You cannot hear a ringtone/dialling tone.
Base station's phone cord has been replaced.
¥
When purchasing a new cord, ensure that it
has the correct pin connections (page 6).
Appendix
a
#
(page 8).
Best Base and no base sta-
All Calls.
.
43