MATSONIC MS7177C User Manual page 71

Resources Controlled By Default: Auto(ESCD)
You should leave this item at the default Auto(ESCD). Under this set-
ting, the system dynamically allocates resources to plug and play
devices as they are required.
If you cannot get a legacy ISA (Industry Standard Architecture) expan-
sion card to work properly, you might be able to solve the problem by
changing this item to Manual, and then opening up the IRQ Resources
and Memory Resources sub-menus.
In the IRQ Resources sub-menu, if you change any of the IRQ assigna-
tions to Legacy ISA, then that Interrupt Request Line is reserved for a
legacy ISA expansion card. Press <Esc> to close the IRQ Resources
sub-menu.
In the Memory Resources sub menu, use the first item Reserved
Memory Base to set the start address of the memory you want to reser-
ve for the ISA expansion card. Use the second item Reserved Memory
Length to set the amount of reserved memory. Press <Esc> to close
the Memory Resources sub-menu.
PCI/VGA Palette Snoop Default: Disabled
This item is designed to overcome some problems that can be caused
by some non-standard VGA cards. This board includes a built-in VGA
system that does not require palette snooping so you must leave this
item disabled.
Assign IRQ for VGA/USB Default: Enabled
Names the interrupt request (IRQ) line assigned to the USB/VGA (if any)
on your system. Activity of the selected IRQ always awakens the sys-
tem.
INT Pin 1 ~ Pin 4 Assignment Default: Auto
Names the interrupt request (IRQ) line assigned to PCI 1 through PCI 4
on your system. Activity of the selected PCI slot awakens the system.
65