MATSONIC MS7177C User Manual page 24

Return the jumper cap to the Normal operation setting. Recon-
nect the power cables and start the system. When the POST
starts, press the delete key to start the BIOS Setup Utility and
reload BIOS optimal settings. Refer to Chapter 3 for information
on BIOS.
Function
Normal operation
Clear CMOS
JP5: Suspend to RAM support enable/disable jumper
Use this jumper to enable or disable the Suspend to RAM (STR)
Function. You must also enable this function in the BIOS Setup
Utility. Refer to Chapter 3.
Function
Enable
Disable
JP6: USB1 wake up jumper
Use this jumper to enable a signal to the USB ports (located on
the I/O port panel) to wake up the system from power saving
mode.
Function
Disable
Enable
JP7: CPU frequency select jumper
This jumper enables you to force the CPU to clock at a higher
frequency than it is rated. Short pins 2 and 3 to force the CPU to
run at a 100 MHz FSB instead of a 66 MHz FSB. We recom-
mend that you leave the jumper on the normal operation setting.
Function
Normal
Force 66 MHz FSB to
run at 100 MHz FSB.
Jumper Setting
Short pins 1-2
1
Short pins 2-3
Jumper Setting
Short pins 1-2
1
Short pins 2-3
Jumper Setting
Short pins 1-2
1
Short pins 2-3
Jumper Setting
Short pins 1-2
1
Short pins 2-3
18
JP1
2 3
JP5
2 3
JP6
2 3
JP7
2 3