MATSONIC MS7177C User Manual page 55

Swap Floppy Drive
If you have two floppy diskette drives in your system, this item allows
you to swap the assigned drive letters so that drive A becomes drive B,
and drive B becomes drive A.
Boot Up Floppy Seek
If this item is enabled, it checks the geometry of the floppy disk drives at
start-up time. You don't need to enable this item unless you have a
legacy diskette drive with 360K capacity.
Boot Up NumLock Status
This item defines if the keyboard Num Lock key is active when your
system is started.
Gate A20 Option
This item defines how the system handles legacy software that was
written for an earlier generation of processors. Leave this item at the
default value.
Typematic Rate Setting
If this item is enabled, you can use the following two items to set the ty-
pematic rate and the typematic delay settings for your keyboard.
Typematic Rate (Chars/Sec)
If Typematic Rate Setting is enabled, you can use this item to define
how many characters per second are generated by a held-down key.
Typematic Delay (Msec)
If Typematic Rate Setting is enabled, you can use this item to define
how many milliseconds must elapse before a held-down key begins
generating repeat characters.
Security Option
If you have installed password protection, this item defines if the pass-
word is required at system start up, or if it is only required when a user
tries to enter the Setup Utility.
Default: Disabled
Default: Enabled
Default: On
Default: Normal
Default: Disabled
Default: 250
Default: Setup
49
Default: 6