MATSONIC MS7177C User Manual page 67

ACPI Suspend Type Default: S1 (POS)
Use this item to define how your system suspends. In the default,
S1(POS), the suspend mode is equivalent to a software power down. If
you select S3 (STR), the suspend mode is a suspend to RAM – the
system shuts down with the exception of a refresh current to the system
memory.
PM Control by APM Default: Yes
This field allows you to control the PC Monitor's power management
features via Intel-Microsoft Advanced Power Management software.
Once you have enabled the APM interface, some settings made in the
BIOS Setup program may be overridden by APM.
Video Off Option Default: Suspend --> Off
This option defines if the video is powered down when the system is put
into suspend mode.
Video Off Method Default: DPMS Support
This item defines how the video is powered down to save power. This
item is set to DPMS (Display Power Management Software) by default.
MODEM Use IRQ Default: 3
If you want an incoming call on a modem to automatically resume the
system from a power-saving mode, use this item to specify the interrupt
request line (IRQ) that is used by the modem. You might have to con-
nect the fax/modem to the mainboard Wake On Modem connector for
this feature to work.
Soft-Off by PWRBTN Default: Instant-Off
Under ACPI (Advanced Configuration and Power management Inter-
face) you can create a software power down. In a software power down,
the system can be resumed by Wake Up Alarms. This item lets you in-
stall a software power down that is controlled by the normal power
button on your system. If the item is set to Instant-Off, then the power
button causes a software power down. If the item is set to Delay 4 Sec.
then you have to hold the power button down for four seconds to cause
a software power down.
61