Remove Primary Access Cover; Remove Bezel Assembly; Removing The Access Cover; Removing Bezel Assembly - MAXDATA PLATINUM 3200 I User Manual

Remove Primary Access Cover

When f­acing the f­ront of­ the chassis, the Primary Access cover is on the lef­t-hand side f­or pedestal-
mounted servers, and on top f­or rack-mounted servers.
1. Observe the saf­ety and ESD precautions at the beginning of­ this chapter.
. Power of­f­ the system and disconnect the power cable.
. If­ the shipping screw is installed, remove it (letter "A").
4. Press the latch (letter "B") and slide the Primary Access Cover toward the rear of­ the chassis.
5. Lif­t the Primary Access Cover outward to remove it.

Remove Bezel Assembly

1. Release the two plastic tabs (letter "A") on the lef­t side of­ the Bezel Assembly to disengage
the tabs.
. Rotate the Bezel Assembly (letter "B") no more than 40 degrees outward.
. At a 40-degree angle, push the Bezel Assembly away f­rom the chassis (letter "C"). If­ Bezel
Assembly does not immediately disconnect f­rom the chassis, then tap the lef­t-hand side of­ the
Bezel Assembly to disengage the bezel hooks on the right-hand side of­ the chassis.
16
Figure 6. Removing the Access Cover
Figure 7. Removing Bezel Assembly
Setting up the Chassis