Raid Support; Hardware Requirements; Processor; System Memory - MAXDATA PLATINUM 3200 I User Manual

Callout LED
F. DIMM C1 fault LED
G. DIMM C2 fault LED
H. DIMM B1 fault LED
I. DIMM B2 fault LED
J. DIMM A1 fault LED
K. DIMM A2 fault LED
M. DIMM D2 fault LED
N. DIMM D1 fault LED
O. DIMM E2 fault LED
P . DIMM E1 fault LED
Q. DIMM F2 fault LED
R. DIMM F1 fault LED
S. +5-volt standby LED

RAID Support

The options f­or hard drive conf­iguration are located in the BIOS Setup under "Advanced" > "Mass
Storage Controller Conf­iguration".
The option "On-board SATA Controller" is enabled as def­ault and allows the f­ollowing additional
"SATA Mode" options:
• "Enhanced" – supports up to six SATA devices in Native IDE mode.
• "Compatibility" – supports up to f­our SATA ports [0/1//] in Legacy IDE mode and two SATA
ports [4/5] in Native IDE mode.
• "AHCI" – supports all SATA ports in Advanced Host Controller Interf­ace mode.
• "SW RAID" – switches on Intel
RAID 0, 1 and 10.

Hardware Requirements

Processor

One or two Intel
®

System memory

The server board provides six memory channels, each with two slots. Channels A to C with DIMM A1,
A, B1, B, C1 and C are assigned to processor 1. Channels D to F with DIMM D1, D, E1, E, F1 and
F are assigned to processor . Channels D, E and F can only be used if­ processor  is populated.
If­ two processors are populated, then they can both access the entire memory via Intel
Interconnect (Intel
Within a channel, DIMM 1 must be populated bef­ore DIMM  can be used.
Channel A
A1 A2
8
Function
These LEDs indicate a fault has occurred with the DIMM in-
stalled in the corresponding socket. Replace the faulty DIMM.
This LED is green whenever AC power is applied to the
system. The system does not need to be powered on in order
for this LED to be on.
Embedded Server RAID Technology II mode with support f­or
®
Xeon 5500 processors must be installed.
®
QPI).
®
CPU socket 1
Channel B Channel C
B1 B2 C1 C2
CPU socket 2
Channel D Channel E
D1 D2 E1 E2
QuickPath
®
Channel F
F1 F2
Server Board Features