Konica Minolta BIZHUB 750 User Manual page 87

Before making copies
!
Detail
When the control panel is turned on by using the sub power switch, the
indicator on the [Start] key lights up in orange, and a screen indicating
that the machine is starting up appears.
After a few seconds, the message "Now warming up. Ready to scan."
appears on the touch panel, and the indicator on the [Start] key lights up
in green, indicating that a job can now be queued.
!
Detail
The default settings are those that are selected immediately after the
machine is turned on (the power switch is set to "I") and before any
setting is specified from the control panel or touch panel, and those that
are selected when the [Reset] key is pressed to cancel all settings
specified from the control panel or touch panel. The default settings can
be changed. For more details, refer to "Initial setting" on page 13-32.
The factory default settings are the settings that were selected when this
machine was sent from the factory.
Note
A job can also be queued while the machine is warming up after the sub
power switch is turned on. For details, refer to "To scan during warm-up"
on page 3-28.
bizhub 750/600 (Phase 2)
3
3-27