Konica Minolta BIZHUB C250 Operations page 502

14
Terms
F
G
H
L
14-8
Description
Factory default set- The value set at the factory. You can change some de-
ting faults by the Utility Mode. It is useful to set the value that
you use frequently as the default.
FAX ID The ID code to recognize each other at the fax communi-
cation. The telephone number is usually registered as the
FAX ID.
F-code It defines the use of the sub-address of T.30* standardized
by ITU-T. You can use various functions of the F-code in
the fax communication among facsimiles supporting the
F-code function even if their manufactures are different. In
this machine, the F-code is used in the bulletin board, re-
lay request, confidential communication and ID transmis-
sion. (* This is one of the communication standards.)
Frame Erase The function to erase dark bands reproduced when the
original is a book or read with the ADF left open.
G3 One of the fax communication modes standardized by
ITU-T. There are G3 and G4 in the communication mode.
G3 is the most used communication mode now.
Group To group multiple abbreviated numbers. It is useful if you
frequently use the sequential multiple station transmission
or the polling reception. You can register up to 500 abbre-
viated numbers in a group.
Horizontal scanning The horizontal direction when the original is scanned.
Long original The function to transmit pages longer than the length (420
mm/16.5 inch) of 11 e 17 size. If you attempt to send such
a long document without selecting Long original mode,
paper misfeed will occur. When Long original mode is se-
lected, pages of up to 800 mm can be transmitted.
LDAP Abbreviation of Lightweight Directory Access Protocol. A
protocol to access mail addresses of users using a net-
work or database to control information on the environ-
ment, through the Internet, Intranet, or other TCP/IP
networks.
Appendix
bizhub C250 (Phase3)