Manual Transmission - Konica Minolta BIZHUB C250 Operations

3
3.8

Manual transmission

This operation is performed when sending documents and confirming the
status of the receiving machine.
Manual Transmission allows you to combine the keypad, [Program] and
[Address Book] to transmit the data to multiple destinations.
Memory transmission cannot be used with manual transmission.
1
Press [Fax] on the control panel to display the fax screen.
2
Place the original.
– For details, see "Placing the original on the machine" on page 3-7.
3
Press [Off-Hook].
– If [RX] has been selected, press [TX] to switch to the transmission
mode.
4
Set the functions of Scan Setting as necessary.
– See "Setting transmission conditions" on page 3-12 for setting
functions on the fax screen.
– See "Application functions overview" on page 7-5 for setting
functions on the fax Application screen.
5
Select the destination with the keypad, [Program] or [Address Book].
– You can input up to 60 digits.
– Pressing [On-Hook] returns the display to the fax screen.
– When an external telephone is connected, documents can be sent
by lifting up the receiver of the external telephone.
6
When the signal sounds, press [Start] of the Off-Hook screen.
– Pressing [Start] on the control panel allows the Off Hook Start Fax
communication screen confirmation to appear. Transmission starts
when you press [Yes].
– When the external telephone is connected, hang up the receiver of
the external telephone after pressing [Start].
Transmission begins.
3-38
Transmission
bizhub C250 (Phase3)