Attaching The Control Panel; Turning On; Turning Off; Selection And Setting Of Sound Settings - Silvercrest KH 2389 Operating Instructions Manual

Assembly / Operation
· Attach the fi xing screw
washer to the holder and assembly cut-out of
the car.
· Ensure that there is voltage on the vehicle's
connection cables for the 12 V DC power supply.
The LED (red) dq fl ashes.
· With a tip of a biro press the Reset button
the front of the device once (see Fig. C).
í

Attaching the control panel

· Take the control panel
· Avoid touching the display window
· Place the rear left edge of the control panel
to the attaching points
device.
· Carefully press the rear right edge of the control
1
panel against the eject mechanism
the device's front until it distinctly snaps on.
í
Operation
í

Turning On

· Press and hold the
two seconds.
The device is supplied with the following fac-
tory settings
· The display window
· The background is lit blue (to be adjusted in 2
levels).
· Tip the
DIM
dimming level.
· The tuner is activated and the display window
7 reads FM 1,
87.50 (broadcasting frequency), [EON] fl ashes,
[AF] fl ashes as does the volume level.
· The loudspeakers play the tuner reception.
· Set the desired volume by turning the SEL / VOL
cp
dial .
14 GB
KH2389_Radio_content_UK.indd 14 KH2389_Radio_content_UK.indd 14
fr with the M5 nut and
dr
to
1
1 from the storage box.
7 .
1
dn to the front of the
do
of
button cq for
DIM
7
reads [WELCOME].
button cq and adjust the
í

Turning off

· Press and hold the
seconds. The background light of the control
panel 1 goes out and the display window
reads [GOODBYE]. When turning off, the device
stores all settings from the last operation. When
turning the device on again, the last used audio
storage medium or the tuner starts to play.
í
Selection and setting
of sound settings
Your settings are stored automatically
VOL: Volume of loudspeakers
cp
· Press the SEL / VOL dial
reads [VOL].
· Set the desired volume of the loudspeakers by
turning the SEL / VOL dial
BAS: Bass
· Press the SEL / VOL dial cp
[BAS].
· Set the desired bass level by turning the SEL /
VOL dial cp .
TRE: Treble
cp
· Press the SEL / VOL dial
reads [TRE].
· Set the desired treble level by turning the SEL /
cp
VOL dial .
BAL: Balance (loudspeaker ratio between left and
right)
· Press the SEL / VOL dial cp
reads [BAL].
· Set the desired balance level by turning the
cp
SEL / VOL dial .
FAD: Fade in and fade out (loudspeaker ratio of front
and rear loudspeakers)
cp
· Press the SEL / VOL dial
reads [FAD].
· Set the desired fading level by turning the SEL /
VOL dial cp .
button cq for two
DIM
7
until the display
cp
.
until the display reads
until the display
until the display
until the display
08.09.2005 11:39:04 Uhr 08.09.2005 11:39:04 Uhr