Remote Control Battery; Changing The Battery - Silvercrest SKRI 2000 A1 Operation And Safety Notes

Appliance battery
Inserting / replacing the battery
GB

Remote Control Battery

Activating the battery

Changing the battery

118
With the insertion of a battery you can avoid the loss of programmed times
and dates plus alarm times in the event of a possible power failure. The battery
ensures that the internal clock and date continue to run even during a power
failure. The display will then automatically show the correct time on the resto-
ration of mains power.
NOTICE
► The appliance can also be operated without a battery.
♦ Open the cover of the battery compartment
appliance by turning the cover with a coin as far as it will go to the left
and then lifting it off .
♦ Insert the battery type CR2032 (supplied) into the battery compartment.
The side with the marking + points upwards.
♦ Close the battery compartment by attaching the cover and then, using a
coin, turn it all the way to the right.
The remote control battery is already inserted when delivered.
♦ Activate the battery by removing the isolation strip.
♦ Using a fingernail press the recess (A) to the right
and, at the same time, pull the battery compart-
ment out.
♦ Insert a 3 V battery of type CR 2025 in the
battery compartment. The side with the marking
"+" must point upwards.
♦ Slide the battery compartment completely back
into the remote control.
Setting up and connecting
24
on the underside of the
SKRI 2000 A1