HP VECTRA XW User Manual page 92

Using the Start-Up
Center
Parallel Ports and
Serial Ports
3 Troubleshooting Your PC Workstation and Using the Setup Program
Using the HP Setup Program
The Start-Up Center lets you choose which system devices the
computer can start (boot) from. Some options will not be available if you
selected
Operating System . . . Microsoft Windows NT
or .
Other
Start-Up Center
Control
Start from Flexible Disk
Start from CD-ROM . . . . . . . Enabled/Disabled
Start from Hard Disk
Start with Network
Protocol . . . . . . . . . . . Not used/Novell/Microsoft
Priority Selected
Priority 1 . . . . . . . . . . . Flexible Drive
Priority 2 . . . . . . . . . . . IDE Hard Disk
Priority 3 . . . . . . . . . . . SCSI Hard Disk
Priority 4 . . . . . . . . . . . Network
The
Priority Selected
be changed.
Use these options to select a combination of I/O address and IRQ
channel for the parallel port and for the serial ports.
To configure a parallel port mode, highlight
select ,
Centronics
Parallel Port . . . . . . . . . . . Parallel 1 (378h, IRQ7)
Parallel Port Mode
Serial Port A . . . . . . . . . . . Serial 1/2/3/4/Off
Serial Port B . . . . . . . . . . . Serial 1/2/3/4/Off
80 English
Setup xxx.xx.xxx.xx
. . . Enabled/Disabled
. . . . . Enabled/Disabled
. . . . . . Enabled/Disabled
items are for information only and cannot
, or .
EPP ECP
. . . . . . . . Centronics/EPP/ECP
,
F1=Help On/Off
Parallel Port Mode
,
OS/2
and