HP VECTRA XW User Manual page 73

System boot process
failed. Press any
key to try again.
Operating System Messages that May Prevent Your PC Workstation From Starting:
Non-system disk
or disk error
Not ready error
reading (or
writing) drive x
3 Troubleshooting Your PC Workstation and Using the Setup Program
Explanation:
You tried to start the PC Workstation but the system could
not find the operating system.
What you should do:
• check the diskette contains the operating system
• check the hard disk contains the operating system
• ensure "start from the flexible disk" or "start from the
hard disk" is enabled in Setup
• for a network, ensure "remote start" is enabled in
Setup.
What you should do:
Remove the diskette, or replace it with the proper operating
system diskette, and press any alphanumeric key to continue.
Explanation:
The device specified in the error message is not ready to accept
or transmit data. This could occur if:
• The diskette has not been inserted correctly. If this is the
problem, reinsert the diskette and type ''R'' (for Retry).
• The printer is not working—ensure it is on and ready to print.
• The device has been disabled using Setup.
If Your PC Workstation Does Not Start
English 61