HP VECTRA XW User Manual page 71

3 Troubleshooting Your PC Workstation and Using the Setup Program
What you should do:
61xx, 6500,
6510, 6520
1 Ensure the memory modules are installed correctly (refer to chapter 2).
8x06
2 If this does not fix the problem, initialize the system ROM (refer to "If You
Can't Start the Setup Program" in this chapter on page 68).
3 If the problem persists, the system board may need to be replaced.
Contact your service representative.
What you should do:
65xx, 66xx
1 Disable all shadowing with the Setup program.
2 If this fails to correct the problem, the system board may need to be
replaced. Contact your service representative.
What you should do:
8060
1 Check that the hard disk drive has not been disabled with the Setup
program.
2 Check that the disk power and data cables are correctly connected (refer
to chapter 2).
If Your PC Workstation Does Not Start
English 59