HP VECTRA XW User Manual page 60

Completing the
Installation of an IDE
CD-ROM drive
Completing the
Installation of a Flexible
disk drive
2 How to Install Accessories Inside Your PC Workstation
Installing Disk Drives
10 Remove the plastic panel from the cover by pulling the panel from
the left and unhinging its right-hand side. Store the panel in a safe
place.
11 Install any other accessories before replacing the cover and
completing the installation.
1 Turn on the computer and press
2 In the Setup program, make sure that the CD-ROM drive has been
detected on the correct IDE channel.
3 Press to save and exit the program.
1 Turn on the computer and press
2 Check that the Setup program has detected the drive in the
Flexible Disk Drives
3 Press to save and exit the program.
48 English
Unclip and lift out
the plastic panel
when
<Setup=F2>
when
<Setup=F2>
section.
appears.
appears.