Advertisement
Available languages
Available languages
HOW TO REMOVE RANGE
FOR SERVICING
Follow
these
procedures
to remove
appliance
for
servicing:
1. Shut off gas supply to appliance.
2. Disconnect electrical supply to appliance, if equipped.
3. Disconnect gas supply tubing to appliance.
4. Slide range forward to disengage range from the
anti-tip bracket. (See page 4).
5. Reverse procedure to reinstall. If gas line has been
disconnected, check for gas leaks after reconnection.
NOTE:
A qualified servicer should disconnect and
reconnect the gas supply.
The servicer
MUST follow installation
instructions
provided with the gas appliance
connector and the
warning label attached to the connector.
6. To prevent range from accidentally tipping, range must
be secured to the floor by sliding rear leveling leg into
the anti-tip bracket.
SERVICE-PARTS
INFORMATION
When your range requires service or replacement parts,
contact your dealer or authorized service agency. Please
give the complete model and serial numbers of the range
which is located on the range model number plate.
-12-
Advertisement
