Table of Contents
Advertisement
General Information
Specifications
Refer to individual Technical Sheet for information
regarding specifications.
Model Identification
Complete registration card and promptly return. If
registration card is missing:
• For Jade product call 1-866-820-9401 or visit the Web
Site at www.jadeappliances.com
When contacting provide product information located on
rating plate. Record the following:
Model Number:
Manufacturing Number:
Serial or S/N Number:
Date of purchase:
Dealer's name and address:
Service
Keep a copy of sales receipt for future reference or in
case warranty service is required. To locate an authorized
servicer:
• For Jade product call 1-866-820-9401 or visit the Web
Site at www.jadeappliances.com
Warranty service must be performed by an authorized
servicer. We also recommend contacting an authorized
servicer, if service is required after warranty expires.
Parts
Purchase replacement parts over the phone. To order
accessories for your product call:
• For Jade product call 1-866-820-9401 or visit the Web
Site at www.jadeappliances.com
Receiving Range
Inspect range thoroughly at time of delivery. Immediately
report any visible damage to carrier. Damage not
discovered until after accepting delivery can still be
claimed by using a concealed damage report form,
available from the carrier's agent.
All shipments, i.e., complete range or parts, are shipped
at the buyer's risk. Jade responsibility ends when the
consignment is accepted by the carrier in "good order".
Jade supports damage claims by supplying invoices,
bills, and other documentation as needed. Providing this
assistance, however, does not imply any responsibility
for settling claims. Do not deduct claims for loss or
damage from the invoice and do not withhold payment
pending adjustment of claims. Do not return any units or
parts for credit without written consent.
©2005 Maytag Services
___________________
___________________
___________________
___________________
___________________
16026509
Unpacking Range
• Remove range from packaging create.
• Remove all packing and printed material packed with
range.
• To avoid damage, do not slide range across flooring.
• Remove burner grates, burner caps, grill, and pressure
regulator from packing material.
Functional Operation
Gas Valve
A single gas valve supplies gas to the griddle burner.
Valves contain bimetal arms attached to the valve seats.
These arms are wrapped with a small electric heater coil.
When current range of approximately 3.3 to 3.6 amps
flow through the griddle circuit, the bimetal arm is heated.
Heating the arm causes the arm to bend, allowing gas to
flow through the valve and ignition is caused by the
burner ignitor.
Surface Burners, Griddle, Charbroil
One spark ignitor is used for each burner. The ignitor is
located between the flash tubes covered by a metal
bracket to provide a grounding surface for ignition.
The surface burners have standard typical valves with a
micro switch, which slides onto the shaft of the valve.
When turning the surface valve to the lite position, the
internal shaft of the valve rotates and turns the micro
switch on, allowing ignition at each individual burner.
Spark System
The spark ignition system consists of a solid state
module, spark ignitors, and micro switches.
By turning a surface burner knob to LITE position. The
spark module sends approximately 2 sparks per second
to the spark ignitors. This is achieved by turning the
burner knob, which rotates the micro switch located on
the valve stem. Which causes a demand for spark from
the spark module containing an electronic circuit which
produces high voltage pulses.
11
Advertisement
Table of Contents
