List Trace Ras Command Example - Avaya ESS User Manual

5. From the Maintenance Web Interface:
Click on the License File command. Verify that the license mode is normal.
●
6. Use the SAT command status ess clusters to verify that a translation file has been
sent to this ESS server. The translation file is only sent after a successful registration. If a
translation file has never been sent it is an indication of either serious network connectivity
issues or Avaya Communication Manager administration and/or configuration errors. See
above.

list trace ras command example

The list trace ras ip-address x.x.x.x command can be used to monitor registration
requests from an ESS server and the associated response from the Main server.
1. Find IP addresses
First determine the IP addresses of the systems involved.
From the Main server execute the display system-parameters ess command. Note the
IP addresses of the Main Server and the ESS server in question. See
Figure 49: Troubleshooting - display system-parameters ess example
display system-parameters ess
ENTERPRISE SURVIVABLE SERVER INFORMATION
Cl Plat
ID Type
---------------------------------------------------------------------------
100 Simplex 4
500 Duplex
600 Simplex 60
From the ESS server that is to be monitored use the Maintenance Web Interface and the
Configure Server command to display the Configure ESS page. Note the IP Address that is
configured as the Main server Primary Address. See
Server A
ID IP Address
135.9 .72 .162
ENTERPRISE SURVIVABLE SERVERS
97
135.9 .78 .143
123.123.123.123
. . .
Enterprise Survivable Server - Troubleshooting
Server B
ID IP Address
MAIN SERVERS
99 135.9 .78 .144
. . .
Figure 50.
Figure 49.
Page 1 of
Pri Com Sys Loc Loc
Scr Prf Prf Only
50 1 y n
1 1 y n
1 1 y n
Issue 1.1 June 2005
7
n
n
n
167