Avaya ESS User Manual page 159

status ess port-networks field descriptions (continued)
Field Description
Com Num The community number of the Port Network (1 - 64) assigned to the Port
Network on display system-paramters. Port networks have a
natural attraction for local preferred media servers in the same community.
In the event of loss of connectivity with their server, they prefer to be
controlled by a server in their community if possible.
Intf Loc Interface Location. Board location of the most recent interface in the Port
Network with which the system tried to control the Port Network.
The interface may be any circuit pack through which the Port Network may
be controlled, such as a TN2312 IP Server Interface (IPSI), a TN2305B or
TN2306B ATM Expansion Interface (ATM EI), or a TN570D Expansion
Interface (CSS EI):
Intf Type The type of interface whose location is shown in the Intf Loc field:
Port Ntwk Ste The Port Network state from the point of view of the server on which
status ess port-networks is run:
The Port Network is up from the perspective of the media server that is
controlling the Port Network.
The Port Network is down from the perspective of all other media servers.
IPSI Gtway Loc IPSI Gateway Location. The location of the IPSI whose Packet Interface
(PKTINT) is being used to deliver packet traffic to the packet bus in this Port
Network. The IPSI may be in this Port Network (this location is the same as
Intf Loc), or it may be in a different Port Network.
Pri / Sec Loc The location of the Primary and Secondary IP Server Interface (if any) in
this Port Network.
Enterprise Survivable Servers - Maintenance Commands
blank = there is no interface
●
IPSI = IP Server Interface
●
EI = either type of Expansion Interface (TN570 or TN2305/2306)
●
UNKN = the interface type cannot be determined
●
blank = there is no interface
●
up = the Port Network is up
●
down = the Port Network is down
●
unkn = the state is unknown
●
blank = there is no Port Network state
●
If the Port Network has a single IPSI, only one line is displayed.
●
If the Port Network has duplicated IPSIs equipped, each is displayed
●
on successive lines.
blank = the Port Network has only an Expansion Interface from which
●
it is controlled
2 of 4
Issue 1.1 June 2005 159