16.5. Auto Trigger Specifications
Auto trigger is enabled when inserting a gray-colored paper on a black backing paper.
Trigger is also enabled when inserting a black-colored paper on a gray backing paper.
Conditions
Paper used for the test
Size of backing paper
Size of detected paper
Moving speed
Ambient temperature and humidity
Ambient illuminance
Figure 29: Auto trigger settings
16.6. Auto Trigger Settings
Use the following settings to enable or disable the auto trigger. (Auto trigger is disabled
by default).
•
To enable auto trigger, scan "ZZ", "+I" and "ZZ" in that order.
•
To disable auto trigger, scan "ZZ", "+F" and "ZZ" in that order.
Functions
SET
Disable auto trigger
Enable auto trigger
END
Note: Please configure the following after enabling the auto trigger.
Black paper from Glory (Black 010010016)
Gray paper from Glory (Silver-gray 010010016)
Larger than the scanning area.
Larger than the detection area
105 mm/s or slower
Room temperature and humidity
300 lx or higher
Menu labels
Menu codes
_ZZ_
ZZ
_+F_
+F
_+I_
+I
_ZZ_
ZZ
43
Opticon
OPI 2002
Specifications Manual