10
7
After the test pattern is printed, the screen changes, as shown below.
8
Place the printed test pattern on the original glass with the edge with
the printed crop marks aligned along the document scale.
9
Place 10 more sheets of blank paper of the same size on top of the
printed test pattern page.
10
Close the original cover, or the duplexing document feeder if it is
installed.
11
Press the [Start] key.
The printed test pattern is scanned.
12
Based on the scanned image, the gradation levels are automatically
adjusted.
After the gradation levels are adjusted, the Admin. Mode screen
appears again.
13
Repeat steps 5 through 12 three times.
14
Touch [Fin. Time], and then touch [Fin. Time] again in the screen that
appears.
10-40
Administrator Mode Operations
CF2002/CF3102