Table of Contents
Advertisement
Enlarge Display Mode
H
Touch
to change.
The entered length of side Y appears. (For this example, 7 inches
is specified.)
H
After you are finished specifying the paper size settings, continue
with step 8.
H
If custom paper sizes have been
programmed, instead of
performing steps 4 and 5, a
programmed paper size setting
can be selected by pressing [1]
or [2].
6
Use the keypad to type in the length of side X for the paper that is
loaded. (between 140 mm and 457 mm)
The entered length of side X appears. (For this example, 140 mm is
specified.)
7
Touch [Y], and then use the keypad to type in the length of side Y for
the paper that is loaded. (between 90 mm and 311 mm)
The entered length of side Y
appears. (For this example, 300 mm
is specified.)
If custom paper sizes have been
programmed, instead of performing
steps 6 and 7, a programmed paper
size setting can be selected by
pressing [1] or [2].
8
Touch [Enter], and then touch [Enter] in the next screen that appears.
H
The paper size for the 1st drawer is set.
CF2002/CF3102
until the cursor moves below the fraction that you wish
8
8-27
Advertisement
Table of Contents
