7
4
Touch [Change Position]. The Change Position screen appears.
5
Select the desired position for the punched holes, and then touch
[Enter].
Note
If a stapling or hole-punching setting is selected, be sure to load the
document so that it is positioned correctly.
If the document is not positioned correctly, the staples or punched
holes will not be positioned correctly.
The correct position of the document is shown in the screen. Be sure
to position the document according to the instructions that appear.
Example: Document position when the "4-Hole Punch" setting is used
The example shows that the document should be positioned so that
the top of the document is toward the rear of the copier.
For details, refer to "Feeding the Document" (p. 5-5).
7-18
Advanced Operations
CF2002/CF3102