MAINTENANCE WORK ON CHASSIS AND ENGINE
Draining the gear oil
x
9.87
Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Drain the gear oil only when the engine is warm.
Filling up with gear oil
x
9.88
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
Adding gear oil
x
9.89
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
–
Stand the motorcycle on its side stand on a horizontal surface.
–
Place a suitable container under the engine.
–
Remove the oil drain plug with magnet
–
Completely drain the gear oil.
–
Thoroughly clean the oil drain plug with magnet.
–
Clean the sealing area on the engine.
–
Fit and tighten the oil drain plug with magnet and seal ring.
Guideline
Oil drain plug with magnet
700515-01
–
Remove screw cap
Gear oil
–
Mount and tighten screw cap.
Danger
Danger of poisoning Exhaust gases are poisonous and can result in uncon-
sciousness and/or death.
–
When running the engine, always make sure there is sufficient venti-
700516-01
lation, and do not start or run the engine in a closed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
–
Check the gear oil level. (
–
Remove gear oil level check screw
700525-01
.
M12x1.5
and fill up with gear oil.
0.20 l (0.21 qt.)
Gear oil (ATF Dexron 3) (
p. 57)
.
58
20 Nm
(14.8 lbf ft)
p. 76)