MAINTENANCE WORK ON CHASSIS AND ENGINE
Removing the seat
9.64
Mounting the seat
9.65
Cooling system
9.66
–
Briefly strike each spoke with the blade of a screwdriver.
Info
The frequency of the tone depends on the spoke length and diameter.
If you hear different tone frequencies from spokes of the same length and
thickness, this is an indication that the spoke tension differs.
You should hear a high note.
»
If the spoke tension differs:
400694-01
–
Correct the spoke tension.
–
Check the spoke torque.
Guideline
Spoke nipple
Torque wrench with various accessories in set (58429094000)
–
Open quick release
–
Pull back the seat and remove it.
300611-10
–
Hook the seat onto screw
Projection
300612-10
–
Close quick release
300611-11
The water pump
The pressure resulting from the warming of the cooling system is regulated by a valve
in the radiator cap
out danger of function problems.
120 °C (248 °F)
Cooling is effected by the air stream.
The lower the speed, the less the cooling effect. Dirty cooling fins also reduce the cool-
ing effect.
700509-01
x
and raise the rear of the seat.
and lower the seat at the rear while pushing it forward.
hooks into the fuel tank.
.
in the engine forces the coolant to flow.
. The specified coolant temperature is therefore permissible with-
M3.5
3 Nm (2.2 lbf ft)
48