Installing The Air Filter; Cleaning Air Filter; Carburetor - Idle (50 Sx) - KTM 50 SX MINI 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Installing the air filter

x
9.77

Cleaning air filter

x
9.78
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Do not clean the air filter with fuel or petroleum since these substances attack the foam.
–
Remove the air filter.
x
–
Wash the air filter thoroughly in special cleaning liquid and allow it to dry properly.
Air filter cleaner ( p. 78)
Info
Only press the air filter to dry it, never wring it out.
–
Oil the dry air filter with a high/quality filter oil.
Oil for foam air filter (
–
Clean the air filter box.
–
Check carburetor connection boot for damage and tightness.
–
Install the air filter. x (

Carburetor - idle (50 SX)

9.79
–
Press the rear holding lugs
Pull out the front holding lug and take off the air filter cover.
–
Take off the air filter.
700504-01
–
Position the clean air filter.
–
Position the rear holding lug. Lower the air filter cover and allow the front holding
lug to snap in.

–
Mount the seat. (
700505-01
( p. 52)
p. 78)
p. 53)
The idle setting of the carburetor has a big influence on the starting behavior, stable
idling and the response to throttle opening. That means that an engine with a correctly
set idle speed is easier to start than if the idle is set wrongly.
Info
The carburetor and its components are subject to increased wear caused by
engine vibration. Wear can result in malfunctioning.
The idle speed is adjusted with the idle adjustment screw
700520-01
The idle mixture is adjusted with the idle mixture adjustment screw
together slightly and swing the air filer cover upward.

Info
If the air filter is not correctly mounted, dust and dirt can penetrate into the
engine and can cause damage.
p. 48)
53
.

.
