Removing Rear Wheel; Installing The Rear Wheel - KTM 50 SX MINI 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing rear wheel

x
9.59

Installing the rear wheel

9.60
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Lift the front wheel into the fork, position it, and insert wheel spindle
washer
700503-10
–
Position washer
–
Mount and tighten nut
Guideline
Front wheel spindle nut
–
Remove the motorcycle from the work stand. (
–
Operate the hand brake lever several times until the brake pads are lying correctly
on the brake disc.
700502-10
–
Jack up the motorcycle. (
–
Remove nut
–
Remove the washer
–
Pull out the wheel spindle
–
Remove the chain from the rear sprocket.
–
Take the rear wheel out of the swing arm.
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
700495-01
aged.
x
–
Clean and grease wheel spindle
Long-life grease (
–
Lift the rear wheel into the swingarm and place the chain on the rear sprocket.
–
Insert the wheel spindle
–
Position washer
–
Check chain tension when installing the rear wheel. (
–
Make sure that the chain adjuster supports are fitted correctly on the adjusting
screws.
–
Tighten nut
Guideline
700496-01
Nut, rear wheel spindle
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc
and there is a tight spot.
–
Remove the motorcycle from the work stand. (
.

.

.

p. 20)
.

.

with the washer

.

p. 78)
with the washer

. Mount nut , but do not tighten it yet.
 
.


M12x1 40 Nm
(29.5 lbf ft)
p. 20)
.

.

p. 34)
M12x1 40 Nm
(29.5 lbf ft)
p. 20)
46
with