Cleaning; Cleaning Motorcycle - KTM 50 SX MINI 2010 Owner's Manual

CLEANING

Cleaning motorcycle

11.1
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
Never clean the vehicle with high-pressure cleaning equipment or a strong water-jet. The excessive pressure can penetrate electri-
cal components, socket connects, throttle cables, and bearings, etc., and can damage or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance are maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
–
Before you clean the motorcycle, seal the exhaust system to prevent penetration by water.
–
First remove coarse dirt particles with a gentle water spray.
–
Spray very dirty areas with a normal motorcycle cleaner and then clean with a brush.
Motorcycle cleaner ( p. 78)
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
–
After rinsing the motorcycle with a gentle water spray, allow it to dry thoroughly.
Warning
Danger of accidents Reduced braking efficiency due to wet or dirty brakes.
–
Clean or dry dirty or wet brakes by riding and braking gently.
–
After cleaning, let your child ride the vehicle a short distance until the engine warms up and the brakes are dried.
Info
The heat produced causes water at inaccessible positions in the engine and the brakes to evaporate.
–
Push back the protection covers on the handlebar instruments to allow water to evaporate.
–
After the motorcycle has cooled off, oil or grease all moving parts and bearings.
–
Clean the chain. ( p. 33)
–
Treat bare metal parts (except for brake discs and exhaust system) with anti-corrosion materials.
Cleaning and polishing materials for metal, rubber and plastic (
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care product.
Cleaning and polishing materials for metal, rubber and plastic (
–
To prevent electrical problems, treat electric contacts and switches with contact spray.
Contact spray ( p. 78)
p. 78)
p. 78)
66