Lens Installation - Barco CineVERSUM 110 Owner's Manual

2. Installation Guidelines
About horizontal and vertical shift
Image 2-5
Lens shift
What can be learned out of this diagram ?
When shifting completely to vertical+ or vertical -, there is no horizontal shift possible. For maximum vertical shift, the lens should
be horizontally in the middle.
When shifting completely to e.g. horizontal +, there is no vertical shift possible. For maximum horizontal shift, the lens should be
vertically in the middle.
That means :
if the horizontal shift is ↑, the maximum vertical shift is ↓.
if the vertical shift is ↑, the manimum horizontal shift is ↓
2.6.3

Lens installation

How to replace with another lens?
Follow the next procedure:
1. Move the handle (A) of the lens anchor system to the left and take out the lens.
2. Take the new lens assembly out of its packing material and remove the lens caps on both sides.
3. Push the lens, motors at the top, in the lens block gap horizontally, lining up the motor connector on the lens with the connector
on the lens block (B). (image 2-6)
Caution: On a table mounted projector, hold the projector when pushing the lens into the lens block to avoid sliding off from
the table.
4. Move the handle (A) of the lens anchor system to the right (front view, table mount) to lock the lens.
16 R5976697 CINEVERSUM™ 110 12/05/2004