Projector Address; Address Setting - Barco CineVERSUM 110 Owner's Manual

A B C
2
3
1
Image 4-7
Stereo jack pin configuration
A tip: Left channel
B ring: right channel
C screen: common (GND)
D external switch
1 Stereo jack
2 Mono jack
The Remote connection uses a standard two wire cable terminated on each end with a 3.5 mm male
(mono/stereo) phone jack.
This cable is not delivered but is available in most electronic or audio shops.
Directly to one of the IR sensors
1. When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line).
The remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the
remote control unit and the projector IR sensor. (image 4-8)
IR Sensor (C)
45°
45°
Image 4-8
Remote control to IR sensor
A IR sensor on front
B IR sensor on top
C IR sensor

4.8 Projector address

Overview
•

Address setting

• Displaying and Programming addresses into the RCU
4.8.1 Address setting
Projector address
Address installed in the projector to be individually controlled.
R5976697 CINEVERSUM™ 110 12/05/2004
D
1
2
IR Sensor on Front (A)
IR Sensor on Top (B)
4. Getting Started
39