Switching On; Lamp Runtime - Barco CineVERSUM 110 Owner's Manual

4. Getting Started

4.2 Switching on

How to switch on.
1. Press the power switch to switch on the projector.
- When '0' is pushed in, the projector is switched off.
- When '1' is pushed in, the projector is switched on
The projector starts in standby mode, LED3 is 0.2 sec on and 2 sec off.
Starting image projection.
1. Press Standby key once on the local keypad or on the remote control.
Note: It may take about 60 seconds before image projection, i.e. no projection until the completion of several operations (soft-
ware initialization,...).
Note: If the Security mode is enabled, a text box will be displayed for PIN code entry, see Security setting in the Installation
menu
Note: If Identification screen is on, the Identification screen will be displayed during start up.
C
AUTION
displayed.

4.3 Lamp runtime

x
To generalize for the different projector types, x refers here to the maximum run time of the lamp.
Lamp runtime indication while running
Independently of the lamp mode, when the total runtime of an active lamp (lamp 1 for example) is (1500 -30) hours or more, a
warning message will be displayed.
WARNING !!!
LAMP 1: 1471 hrs
LAMP 2: 1400 hrs
Image 4-3
warning message
This warning message will be repeated at the next start up. Press BACK or MENU to remove the message.
The total lifetime of the lamp (single lamp) for a safe operation is 1500 (x) hours max., do not use it longer. Always replace with a
same type of lamp. Call a BARCO authorized service technician for lamp replacement.
Lamp management when the lamp runtime is reached in the different lamp modes is indicated in the next image.
36
:
Pushing the standby key too long, might cause the projector to shut down right after an image is
R5976697 CINEVERSUM™ 110 12/05/2004